Battery Charging; Installing The Mpt-Ii Printer; Switching The Printer On And Off; Light Indicators - Interacoustics OtoRead Instructions For Use Manual

OtoRead™ Instructions for Use - US
Installing the Sanibel MPT-II printer (optional)
The OtoReadTM communicates with the MPT-II using a wireless connection protocol. Use only the
recommended label printer from provided with the equipment.

Battery charging

The label printer is powered by a Lithium-ion battery. Connect the power charger to the outlet on the left
hand side of the printer. The blue light on the top of the printer will indicate that charging is occurring. In
order to charge the battery you must insert the plug of the charger into the laterally placed socket and plug
the power supply into a power outlet.

Installing the MPT-II printer

1. Open the lid by pushing on the sides, insert paper roll as shown, and
close the lid.

Switching the printer on and off

Light indicators

Green LED Indicator
Off
Off
Off
Off
Off
On
Slow flash
Slow flash
Push POWER BUTTON
OFF. One short beep will be heard at power ON, two short beeps at
power OFF.
The green power indicator will be lit if the printer is powered by battery.
Blue LED Indicator
Fast Flash
On
Slow Flash
On
Off
Off
Slow flash
Off
for two seconds in order to power ON or
Status
Charging
Charging
Battery nearly
discharged
Charging completed
Charging completed
Power ON, battery
Out of paper
Sleep mode
Page 12
2. Insert the battery.
Sound Note
- Power ON
- Power OFF
- -
- Power ON
- Power OFF
Beep -
Beep -
- -