General; Saving Results; Deleting Results - Interacoustics OtoRead Instructions For Use Manual

OtoRead™ Instructions for Use - US
Managing results

General

Users have the option of printing to the thermal printer or transferring results to the OtoRead
TM
Each OtoRead will include one or more of these options. Your specific options will vary depending on the
configuration of the system purchased.

Saving results

TM
The OtoRead automatically saves the results of completed tests in the non-volatile memory that is to say,
tests are saved even if the battery is temporarily discharged. However, the OtoRead
long-term storage of test results.
Please note: Users are strongly encouraged to print/transfer all test results on completion of testing to avoid
potential loss of data.
Save L/R mode:
Save 250 mode:
See Instrument Settings – Save Mode for information on changing the Save mode settings.

Deleting results

TM
The OtoRead holds data in non-volatile memory. The data stays in the memory even after data is printed
by the thermal printer or downloaded to the OtoRead
methods, depending on the Save mode.
When operating in the default 'Save L/R' mode, the OtoRead
the most recent test results for each ear and print/transfer only these
results. This allows the user to retest a patient after a REFER result and
to print/transfer only the most recent test result for each ear. It is
recommended that the results be printed after each patient in the default
mode.
When operating in the 'Save 250' mode, the OtoRead
250 tests. There are two options in the 'Save 250' mode:
TM
1. The OtoRead
250. This allows the user to save all tests for each patient (tests
of the same ear are NOT overwritten) and to test multiple
patients before printing or transferring results. In this mode, it is
important to keep a record of the test number(s) for each patient.
TM
2. The OtoRead
names to the OtoRead
names. When patient names are used, the patient names are
displayed on the OtoRead
on the PC Module. To move to a different name than the one
displayed on the OtoRead
arrows to cycle through the names until the desired name is on
the display. 'Unnamed' is always included at the beginning of
the OtoRead TM
but the patient name was not transferred to the OtoRead
'Unnamed' selection can be used multiple times when
transferring to the PC Module.
TM
Module Software. Data can be deleted via several
will automatically number each test from 1 to
Module Software is used to transfer patient
TM and the OtoRead
TM
Unit in the same order as displayed
TM screen, use the LEFT or RIGHT
list for instances when a patient is being tested,
Page 26
TM
PC Module.
TM
is not intended for
TM will save
TM
will save up to
TM will display the
TM .The