Raisecom Technology Co., Ltd
Set successfully
OPCOM3100(config-snmp)# exit
OPCOM3100(config)# interface dcc 1
OPCOM3100(config-dcc/1)# ip address 192.168.2.66
Set successfully
OPCOM3100(config-dcc/1)# exit
OPCOM3100(config)# interface dcc 2
OPCOM3100(config-dcc/2)# ip address 192.168.3.66
Set successfully
OPCOM3100(config-dcc/2)# work mode client
Set successfully
OPCOM3100(config-dcc/2)# auto-connect
Set successfully
OPCOM3100(config-dcc/2)#
:
OPCOM3100B
OPCOM3100(config)# interface snmp
OPCOM3100(config-snmp)# ip address
OPCOM3100(config-snmp)# ip address 192.168.4.66
Set successfully
OPCOM3100(config-snmp)# exit
OPCOM3100(config)# interface dcc 1
OPCOM3100(config-dcc/1)# ip address 192.168.5.66
Set successfully
OPCOM3100(config-dcc/1)# exit
OPCOM3100(config)# interface dcc 2
OPCOM3100(config-dcc/2)# ip address 192.168.6.66
Set successfully
OPCOM3100(config-dcc/2)# work mode client
Set successfully
OPCOM3100(config-dcc/2)# auto-connect
Set successfully
OPCOM3100(config-dcc/2)#
If two optical interfaces are used at the same time in the network of point to point
topology, ip unnumbered command is not available, then you must configure IP address
for either interface.
9.5.2 Chain topology
Network of chain topology:
23