Table of Contents
Advertisement
5 Configuring network protocols
This chapter includes the following sections:
Configure the mapping from IP address to physical address
Configure IP address of SNMP interface
Configure a static routing
Configure COMMUNITY table of SNMP
Configure SNMP trap server host
5.1 Configure the mapping from IP address to physical
address
Command
config
arp
add
MACADDRESS
exit
show arp
Using the global configuration command arp delete A.B.C.D to delete a mapping
from an IP address to a physical address.
For example: Add a mapping of a IP address 192.168.1.119 to a physical address
00:50:8d:46:fb:3
OPCOM3100# config
Configuration mode, one command input per times. End with CTRL-Z.
OPCOM3100(config)# arp add 192.168.2.11 00:50:8d:46:fb:3
Successfully add an entry from ARP table
OPCOM3100(config)# exit
OPCOM3100# show arp
LINK LEVEL ARP TABLE
destination
--------------------------------------------------------------------------
192.168.2.11
5.2 Configure IP address of SNMP interface
There is the possibility to change the IP address of network management, in this
Description
Enter global configuration mode
A.B.C.D
Add a mapping from one IP address to physical
address.
A.B.C.D
MACADDRESS:
the port's physical address for mapping
Exit
privileged mode
Show ARP table
gateway
00:50:8d:46:fb:3
Raisecom Technology Co., Ltd
the IP address of the interface；
from
global
configuration
flags Refcnt Use
c05
0
0
13
<AA.BB.CC.DD.EE.FF>,
mode
Interface
hw0
to
Advertisement
Table of Contents
