Installation Of System Components - Bennett Marine AutoTrimPro Installation & User Manual

Installation of System Components

Installation of the ATP
Helm Display
Before starting any work, disconnect
the battery(s), and verify that all
power is turned off.
Preparation
Before installing the ATP Helm
Display, check for obstructions on
the underside of the helm. Locate an
appropriate location on the helm for
the ATP Helm Display. The ATP
Helm Display should be installed
such that the vessel operator has a
clear, unobstructed view of the
display, and is easily reachable from
the operating position. Ideally, the
ATP Helm Display should be
installed in a horizontal position.
This makes the use of the control
more intuitive. It is important for the
vessel operator to be able to clearly
see the LED indicators on the ATP
Helm Display to know what the ATP
is doing.
Bennett Marine AutoTrim Pro | Need help? Call (954) 427-1400
1. Use the template included on
Page 17 to help decide the
location for the ATP Helm
Display. The Helm Display
should be located on the helm in
view of the operator, and within
easy reach. It is important for
the vessel operator to be able to
clearly see the LED indicators on
the ATP Helm Display to know
what the ATP is doing. Before
installing the ATP Helm Display,
check for obstructions on the
underside of the helm.
2. Drill the center hole 1" using the
template from page 17.
3. Drill the four 3/16" screw holes.
4. Thread the wires for the ATP
Helm Display through the 1"
hole.
5. Secure the ATP Helm Display
using the four 8-32 nylon thumb
nuts included.
6. Locate the power source for all
of the helm instrumentation.
Connect the orange wire from the
ATP Helm Display to the power
source for the instrumentation.
When power is removed from this
orange wire, the system will shut
down.
7. Locate the ignition
power. Consult the engine
manufacturer's documentation
to identify a source for ignition
power. Connect the purple wire
from the ATP display to the
7