Indication & Manual Mode Buttons - Bennett Marine AutoTrimPro Installation & User Manual

Indication & Manual Mode Buttons
Yellow LED Indication
These LEDs represent the range of
motion that the trim tabs may move
through. The four yellow LEDs will
be illuminated continuously during
normal operation. If one of the upper
yellow LEDs is flashing, this is an
indication to the user that the system
is not receiving a signal from one of
the actuator sensors (see page 20).
Red LED Indication
When the
port tab
is lowered
(deployed),
the port
red LEDs
on the ATP
display will
illuminate.
As a result,
the Stbd.
(right) bow
will lower.
The red LEDs represent the actual
movement of the tabs. As the tabs
move from the full-up position to the
full-down position the red LEDs will
illuminate to illustrate the trim tab
Bennett Marine AutoTrim Pro | Need help? Call (954) 427-1400
deflection. All red LEDs illuminated
indicates that the tabs are fully
deployed (down).
No red LEDs illuminated indicates
that the tabs are fully retracted (up).
If the red LEDs are flashing, the
system does not have a calibration
stored for the position display. See
page 20 for calibration instructions.
Sun & Moon Buttons
The Sun and moon buttons are
used to increase and decrease the
brightness of the LEDs on the
display.
When the
Stbd. tab
is lowered
(deployed),
the Stbd.
red LEDs
on the ATP
display will
illuminate.
As a result,
the port (left)
bow will
lower.
33