Bennett Marine AutoTrimPro Installation & User Manual page 21

System Set Up:
5. Press and hold both BOW UP
buttons. Both actuators should
return to the full-up position.
6. Once calibration is complete, the
four yellow LEDs in the corners
should be continuously on.
Bennett Marine AutoTrim Pro | Need help? Call (954) 427-1400
Actuator Position Calibration
7. Press and hold both BOW DN
buttons until both actuators fully
extend. The red LEDs on the
display should show the actuator
position as the actuators deploy.
8. Press and hold both BOW UP
buttons until both actuators return
to the full-up position. The red
LEDs on the display should
show the actuator position as the
actuators retract.
continued
21