Bennett Marine AutoTrimPro Installation & User Manual page 49

ATP Helm Display has the
two blue LEDs above the
FAV1 and FAV2 buttons
flashing
The ATP Helm Display will flash
the blue LEDs above the FAV1 and
FAV2 buttons when the ATP Control
Unit has not been oriented to the
boat. This is normal as the system
is shipped without an orientation
configuration. The orientation must
be performed with the boat in the
water, and the system completely
functional.
• Potential Cause: The ATP system
has not been oriented following
the ATP Control Unit installation.
• Solution: Verify that the
trim tabs function properly
when the manual buttons
are pressed. Follow the
Orientation procedure on
page 23.
Bennett Marine AutoTrim Pro | Need help? Call (954) 427-1400
Troubleshooting
continued
No response from the
ALL Up button
• Potential Cause 1: The tabs are
already in full-up position.
• Solution: The system is
working as designed.
• Potential Cause 2: The tab
position sensors are not working.
• Solution: Check for a
flashing upper yellow light
on ATP Helm Display. If
the upper yellow LEDs
are flashing, refer to the
installation troubleshooting
section for "Upper yellow
LEDs flashing" on page 45.
No Response from the
ALL DN Button
• Potential Cause 1: The tabs are
already in full-down position.
• Solution: The system is
working as designed.
• Potential Cause 2: The tab
position sensors are not working.
• Solution: Check for a
flashing upper yellow light
on ATP Helm Display. If
the upper yellow LEDs
are flashing, refer to the
installation troubleshooting
section for "Upper yellow
LEDs flashing" on page 45.
49