Planning The Installation - Bennett Marine AutoTrimPro Installation & User Manual

Planning The Installation

Getting Started
AutoTrim Pro requires the
presence of actuator sensor
wires in order to display trim
tab position indication LEDs
(although all other features will
function without sensors). Before
performing the installation, you
will need to determine if you
currently have sensors available,
and whether you will choose to
add or forgo sensor installation.
See the next "Checking for
Sensors" section to verify your
current system.
Installation of the ATP control
system will assume that the
installation of the trim tabs,
actuators, and wiring has been
previously completed according to
thier respective trim tab
installation and users guides which
can be downloaded at
BennettTrimTabs.com/Installation.
The ATP system contains the
following items:
1. ATP Helm Display
2. ATP Control Unit
3. Hardware and Cables
Additional components may be required
for more complex systems. Please call
Bennett Marine at (954) 427-1400 with
any questions.
6 Bennett Marine AutoTrim Pro | Need help? Call (954) 427-1400
Checking for Sensors
Looking at which current Bennett
helm control you have will help
determine if you have sensors or not.
VC1000 LS3000
Sensors will be required
IP1010A TPI2000
You have sensors already
Adding Actuator Sensors
There are two options, you can
replace you current actuators with
new Bennett sensor-equipped
actuators, or you can simply swap
out the upper hinges of your existing
actuators with sensor-equipped upper
hinges–available as a conversion kit.
Call Bennett Marine at (954) 427-
1400 to order.
AutoTrim Pro is
equipped with tab
position indication
LED indicators.
For this feature
to work, actuator
sensors must be
present.
ES2000
EIC5000