Bennett Marine AutoTrimPro Installation & User Manual page 48

Troubleshooting
• Potential Cause 5: The trim tab
system is not functioning properly.
• Solution: The ATP
installation assumes a
fully functioning trim tab
system is in place before
the ATP system is installed.
Refer to the trim tabs
owner's manual for full
installation instructions
and troubleshooting. Also
refer to troubleshooting at
BennettTrimTabs.com or
call our support line at (954)
427-1400 M-F 8AM - 5PM
EST.
Operations
FAV button pressed and
unit will not go into auto
mode
• Potential Cause 1: No FAV
position is stored.
• Solution: Check for a
flashing yellow LED above
the FAV1 or FAV2 buttons
as the FAV button is pressed.
This is an indication that
there is no position stored in
the FAV button that has been
pressed. To store a position,
manually adjust the boat into
the desired attitude using
the throttle, engine trim and
trim tabs. Press and hold the
FAV button. The button must
48
Bennett Marine AutoTrim Pro | Need help? Call (954) 427-1400
continued
• Potential Cause 2: The
orientation has not been
completed.
• Potential Cause 3: The angle set-
up has not been completed.
ATP Helm Display has all
of the red LEDs flashing
The ATP Helm Display will flash
the red LEDs when the actuator
system has not been calibrated. This
is normal as the system is shipped
without a calibration.
• Potential Cause: The ATP
system has not been calibrated for
actuator position information.
be held for at least three
seconds. The ATP will go to
automatic control mode as
soon as the button is released
(See page 37).
• Solution: Follow the
orientation procedure on
page 23.
• Solution: Follow the set-up
procedure on page 24.
• Solution: Verify that the
trim tabs function properly
when the manual buttons
are pressed. Follow the
calibration procedure
beginning on page 20.