Bennett Marine AutoTrimPro Installation & User Manual page 50

Troubleshooting
• Potential Cause 3: The trim tabs
will not auto-deploy because the
orientation has not been properly
performed.
• Solution: Verify that the
trim tabs function properly
when the manual buttons
are pressed. Follow the
Orientation procedure on
page 23.
System comes out of
FAV mode
• Potential Cause 1: A manual trim
tab button, ALL Up or ALL Down
has been pressed.
• Solution: The system
is working as designed.
Pressing any button will
cause the system to exit
automatic operation.
• Potential Cause 2: The system
has detected rough sea conditions.
• Solution: If the system
flashes the blue LEDs
above the FAV1 and FAV2
buttons and stops automatic
operation, the system is
working as designed. The
system will constantly
monitor conditions and when
the system detects excessive
roll conditions or excessive
pounding, the system will
retract the tabs and exit
automatic mode. Under
these kinds of conditions, the
50
Bennett Marine AutoTrim Pro | Need help? Call (954) 427-1400
continued
• Potential Cause 3: Intermittent
power has caused the system to
brown out and restart.
System brings tabs full
up and will not auto
control
• Potential Cause: System has
detected rough sea conditions.
user must operate the trim
tabs manually.
• Solution: Verify the power
connections to the ATP Helm
Display and the ATP Control
Unit. If there is a temporary
power outage the system
will shut down and restart.
After each restart the ATP
Helm Display will flash all
the LEDs starting in the
outside corners and moving
toward the center. Rewire the
system such that the power
source for the ATP display
is a clean, stable source
not affected by voltage
drops when large loads are
operated.
• Solution: If the system
flashes the blue LEDs
above the FAV1 and FAV2
buttons and stops automatic
operation, the system is
working as designed. The
system will constantly
monitor conditions and when
the system detects excessive
roll conditions or excessive