Bennett Marine AutoTrimPro Installation & User Manual page 38

Using Automatic Mode
3. After the user releases the FAV1
or FAV2 button, the system will
immediately go into automatic
operation. When the ATP is in
automatic mode, the FAV1 or
FAV2 button that was pressed
will illuminate with a blue LED
to indicate that the unit is in
automatic mode and trying to
adjust the vessel to the position
stored in the corresponding
button. Automatic operation
is described below. If the user
attempts to go into automatic
mode and there is no position
stored, the FAV1 or FAV2 button
that was pressed will flash a
yellow LED. No automatic
operation will be performed.
Starting Auto Mode
To activate automatic trim tab
operations, press and release the
FAV1 or FAV2 button. In order to
start automatic operations, the unit
must have the FAV position set
(see "Setting a Favorite Position"
on page 37), and the initial set-up
38 Bennett Marine AutoTrim Pro | Need help? Call (954) 427-1400
continued
described on page 23 must have
been already performed.
CAUTION
Pressing and holding either FAV
button for more than 3 seconds will
reset to the current position. The ATP
will then try to maintain the boat in
the new current position.
Exiting Auto Mode
To exit auto mode, any manual or
semi-automatic button (shown
below) can be pressed and the
system will stop automatic control,
allowing the user to control the trim
tabs manually.
For a detailed explanation of how
auto mode works, see the following
section "Understanding Automatic
Operation".