Bennett Marine AutoTrimPro Installation & User Manual page 46

Troubleshooting
ATP Helm Display has all
of the red LEDs flashing
The ATP Helm Display will flash
the red LEDs when the actuator
system has not been calibrated. This
is normal as the system is shipped
without a calibration
• Potential Cause: The ATP
system has not been calibrated for
actuator position information.
• Solution: Verify that the
trim tabs function properly
when the manual buttons
are pressed. Follow the
calibration procedures
beginning on page 20.
ATP Helm Display has the
two blue LEDs above the
FAV1 and FAV2 buttons
flashing
The ATP Helm Display will flash
the blue LEDs above the FAV1 and
FAV2 buttons when the ATP Control
Unit has not been oriented to the
boat. This is normal as the system
is shipped without an orientation
configuration. The orientation must
be performed with the boat in the
water, and the system completely
functional.
• Potential Cause: The ATP system
has not been oriented following
the ATP Control Unit installation.
• Solution: Verify that the
trim tabs function properly
when the manual buttons
46
Bennett Marine AutoTrim Pro | Need help? Call (954) 427-1400
continued
Tabs do not retract when
ignition is turned off
• Potential Cause: The system is
not wired to a power source that
shuts off when the ignition is
turned off.
Display LEDs do not go
off when the ignition is
turned off
• Potential Cause: The system
is not wired to a power source
that shuts off when the helm
instrumentation power is turned
off.
Trim Tabs not responding
when ATP Helm Display
buttons are pressed
• Potential Cause 1: There is no
are pressed. Follow the
Orientation procedure on
page 23.
• Solution: Re-wire to a
power source that shuts off
with the ignition. Connect
the purple wire from the
back of the Helm Display to
a power source that is shut
off by the ignition.
• Solution: Re-wire to power
source that shuts off with
the helm instrumentation
power. Connect the orange
wire from the back of the
Helm Display to a power
source that is shut off by the
ignition.