Table of Contents
Advertisement
HDMI Connection
To secure the HDMI cable to the HDMI input connector, use an Extron LockIt Cable Lacing
Bracket and a tie wrap.
3
1
Figure 6.
1.
Plug the HDMI cable into the panel connection (see figure 6,
2.
Loosen the HDMI connection mounting screw from the panel (
LockIt to be placed over it. The screw does not have to be removed.
3.
Place the LockIt on the screw and against the HDMI connector (
the screw to secure the bracket.
4.
Loosely place the included tie wrap around the HDMI connector and the LockIt (
5.
While holding the connector securely against the cable lacing bracket, use pliers or
similar tools to tighten the tie wrap, then remove any excess length (
ATTENTION:
•
•
3
2
5
Installing the LockIt Cable Lacing Bracket
Connect and pull the tie wraps until they are secure. Do not overtighten.
Connectez et tirez les serre-câbles jusqu'à ce qu'ils soient sécurisés. Ne pas
trop serrer.
4
1
XTP T USW 103 4K Switcher • Installation
).
) enough to allow the
2
), and then tighten
3
).
4
).
5
10
Advertisement
Table of Contents
