Making Connections; Hdmi Connection - Extron electronics XTP T USW 103 User Manual

F
G
H
I

Making Connections

HDMI Connection

Use an Extron LockIt Lacing Bracket to secure an HDMI cable to top mounting screw of an
HDMI connector.
1
Figure 4.
1.
2.
3.
4.
5.
RS-232 Over XTP port — To pass bidirectional serial or other control signals
between XTP-compatible devices, connect a control device to the 5-pole
captive screw connector. The port includes only the 3 poles labeled
"RS-232."
IR Over XTP port — To transmit and receive IR signals (up to 40 kHz),
connect a control device to the 5-pole captive screw connector. This port
includes only the 2 poles labeled "IR" and shares the ground pole with the
RS-232 port.
NOTE: RS-232 and IR data can be transmitted simultaneously (see
Communication on page 7 for wiring details).
Contact closure connector — Connect an Extron KP 6 Keypad Remote Control or
similar device to the 3.5 mm, 4-pole captive screw connector. The first three ports are
used for selecting inputs 1 through 3 when momentarily shorted to the ground port.
Remote RS-232 connector — Connect a host device to the 3.5 mm, 3-pole captive
screw connector for serial control of the switcher.
Power connector and LED — Connect an external power supply to the 3.5 mm,
2-pole captive screw connector (see
lights to indicate the device is receiving power.
NOTE: The XTP T USW 103 can be powered remotely (see
page 9).
3
2
Installing the LockIt Lacing Bracket
Plug the HDMI cable into the panel connection (see figure 4,
Loosen the HDMI connection mounting screw from the panel (see
the LockIt lacing bracket to be placed over it. The screw does not have to be removed.
Place the LockIt lacing bracket on the screw and against the HDMI connector (see
then tighten the screw to secure the bracket.
ATTENTION: Do not overtighten the HDMI connector mounting screw. The shield
to which it fastens is very thin and can easily be stripped.
Loosely place the included tie wrap around the HDMI connector and the LockIt lacing
bracket (see ).
4
While holding the connector securely against the lacing bracket, use pliers or similar
tools to tighten the tie wrap, then remove any excess length (see
Power Connection
4
3
5
XTP T USW 103 Switcher • Installation
RS-232
Tx Rx G Tx Rx
RS-232
Tx Rx G Tx Rx
RS-232 and IR
on page 8). The Power LED
Remote power on
).
1
) enough to allow
2
3
).
5
IR
IR
),
5