Table of Contents
Advertisement
Operation
After all transmitters, all receivers, and their connected devices are powered up, the system
is fully operational. If any problems are encountered, verify that the cables are routed and
connected properly. If problems persist, call the Extron S3 Sales & Technical Support
Hotline. See the contact numbers on the last page of this guide for the nearest Extron office.
This section contains information for front panel operation and configuration of the
XTP T USW 103 4K. Topics in this section include:
•
•
•
•
Front Panel Features
A
AUTO
SWITCH
Figure 11.
A
B
C
D
Front Panel Features
Front Panel Operation
EDID
Reset Mode
B
1
CONFIG
MODE
XTP T USW 103 4K Front Panel
Auto Switch LED indicator — Lights when the switcher is in auto switch mode.
Configuration port — Connect a host device to the front panel USB mini-B
configuration port.
Input selection buttons — Select inputs 1 through 3 or modes of operation. The
corresponding LEDs light to indicate the active input.
Status LED indicators
Signal status LED indicators — Light to indicate the signal presence of each
•
input.
HDCP status LED indicators — Light when the signal on the corresponding input
•
is HDCP-compliant. Input 1 (the VGA connector) does not have an HDCP LED.
Audio Signal Clip LED indicator — Lights when the analog audio input signal is
•
-3 dBFS or above. The light remains lit for 200 ms after the audio input signal drops
below -3 dBFS.
C
SIGNAL
2
3
HDCP
NORMAL
AUTO
XTP T USW 103 4K Switcher • Operation
D
STATUS
1
2
3
AUDIO
SIGNAL CLIP
XTP T USW 103 4K
16
Advertisement
Table of Contents
