Extron electronics XTP T USW 103 4K User Manual page 34

Command
Front panel lockout mode (executive mode)
Set front panel lockout mode
View front panel lockout
mode status
Device name
Set device name
Reset device name
View device name
Reset mode
System reset
Status
View input signal presence
View HDCP input
View firmware version
View full firmware version
View part number
NOTES:
X2!
= Front panel lock mode
X2@
= Device name
X2#
= Input signal presence
X2$
= HDCP status
ASCII Command ASCII Response
(Host to Device) (Device to Host)
X2!
X Exe
X
Exe
E X2@ }
CN Ipn
E • }
CN Ipn
E }
CN Ipn
E }
ZXXX Zpx
0LS
Frq
E }
IHDCP HdcpI0
Q
x.xx
*Q
x.xx.xxxx
N
60-1550-12
= allow front panel operation
0
= prevent front panel operation
1
Text label, maximum seven alphanumeric characters
= no input detected
0
= input detected
1
= no source detected
0
= source is HDCP-compliant
1
= source is not HDCP-compliant
2
XTP T USW 103 4K Switcher • SIS Configuration and Control
Additional Description
X2!] Allow or prevent input switching
or setting switch modes from
the front panel buttons.
X2!]
• X2@]
Reset the device name to the
}
• USW 103
factory default name.
• X2@]
Resets unit to factory default.
]
X2# X2# X2# ] View the input signal presence
1 2 3
of each input. The superscript
number next to the
variables refer to the input
number.
X2$ X2$ ] View the HDCP input status of
2 3
inputs 2 and 3. The superscript
number next to the
variables refer to the input
number.
] View the firmware version.
] View the full firmware version.
] View the device part number.
X2#
X2$
26