Edid; Reset Mode - Extron electronics XTP T USW 103 4K User Manual

EDID

To manage EDID on the XTP T USW 103 4K, use the XTP System Configuration Software
(see
user memory location, select a pre-defined EDID, or use EDID from a display connected to a
receiver. EDID stored in the user memory location can come from the display connected to
a receiver or a custom EDID imported through the XTP System Configuration Software.
NOTE: In matrix applications, EDID on the switcher is assigned by the matrix switcher

Reset Mode

Use the recessed
return the device to default settings or to restore factory-shipped firmware.
Figure 12.
Mode Activation
Press and hold the recessed
button while applying
Reset
power to the device.
Factory
NOTE: After this reset,
Firmware
update the device with the
Reset
latest firmware version. Do
(mode 1)
not operate the device with
the firmware version that
results from this reset.
EDID Minder on page 40). The XTP T USW 103 4K can record and save EDID in a
using the XTP System Configuration Software.
button on the rear panel of the switcher (see figure 12,
Reset
XTP T USW 103 4K
POWER
1
12V
AUDIO
--A MAX
RGB
Rear Panel Reset Button
Rest Mode Summary
Result
The device reverts to the factory
default firmware for a single power
cycle.
NOTE: If this reset was
INPUTS
2 3
HDMI DISPLAYPORT HDMI OUT
performed by mistake or
is no longer desired, cycle
power to the device again to
restore the firmware version
running prior to the reset.
XTP T USW 103 4K Switcher • Operation
) to
A
A
CONTACT TALLY OUT
RS-232
R
1 2 3 G 1 2 3 +V Tx Rx G
SIG LINK
RS-232 IR
XTP OUT LAN
Tx Rx G Tx Rx
Purpose and Notes
Use this reset to return the
firmware back to the factory
firmware temporarily if an
incompatibility issue arises
with the current firmware.
18