Authorized And Unauthorized Client Vlans - HP ProCurve 2910al Access Security Manual

Web and MAC Authentication
Overview
3-4
Each new Web/MAC Auth client always initiates a MAC authentication
■
attempt. This same client can also initiate Web authentication at any time
before the MAC authentication succeeds. If either authentication suc­
ceeds then the other authentication (if in progress) is ended. No further
Web/MAC authentication attempts are allowed until the client is deau­
thenticated.
■ Web and MAC authentications are not allowed on the same port if unau­
thenticated VLAN (that is, a guest VLAN) is enabled for MAC authentica­
tion. An unauthenticated VLAN can't be enabled for MAC authentication
if Web and MAC authentication are both enabled on the port.
Hitless reauthentication must be of the same type (MAC) that was used
■
for the initial authentication. Non-hitless reauthentication can be of any
type.
The remaining Web/MAC functionality, including interactions with 802.1X,
remains the same. Web and MAC authentication can be used for different
clients on the same port.
Normally, MAC authentication finishes much sooner than Web authentication.
However, if Web authentication should complete first, MAC authentication
will cease even though it is possible that MAC authentication could succeed.
There is no guarantee that MAC authentication ends before Web authentica­
tion begins for the client.
Concurrent Web and MAC authentication is backward compatible with all
existing user configurations.

Authorized and Unauthorized Client VLANs

Web-Auth and MAC-Auth provide a port-based solution in which a port
belongs to one, untagged VLAN at a time. The switch supports up to eight
simultaneous client sessions per port. All authenticated client sessions
operate in the same untagged VLAN. (If you want the switch to simultaneously
support multiple client sessions in different VLANs for a network application,
design your system so that clients request network access on different switch
ports.)
In the default configuration, the switch blocks access to all clients that the
RADIUS server does not authenticate. However, you can configure an
individual port to provide limited network services and access to unauthorized
clients by using an "unauthorized" VLAN for each session. The unauthorized
VLAN ID assignment can be the same for all ports, or different, depending on
the services and access you plan to allow for unauthenticated clients.