HP ProCurve 2910al Access Security Manual page 254

Configuring Secure Shell (SSH)
Configuring the Switch for SSH Operation
N o t e o n P o r t
N u m b e r
ProCurve(config) ip ssh
ProCurve(config)# show ip ssh
SSH Enabled
TCP Port Number : 22
Host Key Type
Ciphers : aes128-cbc,3des-cbc,aes192-cbc,aes256-cbc,
rijndael-cbc@lysator.liu.se,aes128-ctr,aes192-ctr,aes256-ctr
MACs : hmac-md5,hmac-sha1,hmac-sha1-96,hmac-md5-96
Ses Type | Source IP
--- -------- + ---------------------------------------------- -----
1 console |
2 telnet |
3 ssh | 12.255.255.255
4 inactive |
5 inactive |
6 inactive |
Figure 7-10. Example of Enabling IP SSH and Displaying the SSH Configuration
7-18
[port < 1-65535 | default >]
The TCP port number for SSH connections (default: 22).
Important: See "Note on Port Number" on page 7-18.
[public-key <manager | operator>]
Configures a client public key.
manager: Select manager public keys (ASCII formatted).
operator: Select operator public keys (ASCII formatted).
[timeout < 5 - 120 >]
Sets the maximum length of time (in seconds) allowed
for initial protocol negotiation and authentication.
Default: 120 seconds
ProCurve recommends using the default TCP port number (22). However, you
can use ip ssh port to specify any TCP port for SSH connections except those
reserved for other purposes. Examples of reserved IP ports are 23 (Telnet)
and 80 (http). Some other reserved TCP ports on the switch are 49, 80, 1506,
and 1513.
Enable SSH
: Yes
: RSA
Secure Copy Enabled : No
Timeout (sec)
Host Key Size
With SSH running, the switch allows one console
session and up to five other sessions (SSH and/or
Telnet). Web browser sessions are also allowed, but
do not appear in the show ip ssh listing.
: 120
: 1024
Port