Named Source-Port Filters; Operating Rules For Named Source-Port Filters - HP ProCurve 2910al Access Security Manual

Hide thumbs Also See for ProCurve 2910al:
Table of Contents

Advertisement

Traffic/Security Filters and Monitors
Filter Types and Operation
11-6
Figure 11-3. The Filter for the Actions Shown in Figure 11-2

Named Source-Port Filters

You can specify named source-port filters that may be used on multiple ports
and port trunks. A port or port trunk can only have one source-port filter, but
by using this capability you can define a source-port filter once and apply it
to multiple ports and port trunks. This can make it easier to configure and
manage source-port filters on your switch. The commands to define,
configure, apply, and display the status of named source-port filters are
described below.

Operating Rules for Named Source-Port Filters

A port or port trunk may only have one source-port filter, named or
not named.
A named source-port filter can be applied to multiple ports or port
trunks.
Once a named source-port filter is defined, subsequent changes only
modify its action, they don't replace it.
This list shows the filter created
to block (drop) traffic from
source port 5 (workstation "X") to
destination port 7 (server "A").
Notice that the filter allows
traffic to move from source port
5 to all other destination ports.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents