Configuring Traffic/Security Filters - HP ProCurve 2910al Access Security Manual

Hide thumbs Also See for ProCurve 2910al:

Table of Contents

Only one filter for a particular protocol type can be configured at any one time.

For example, a separate protocol filter can be configured for each of the

protocol types listed above, but only one of those can be an IP filter. Also, the

destination ports for a protocol filter can be on different VLANs.

You can configure up to seven protocol filters.

Configuring Traffic/Security Filters

Use this procedure to specify the type of filters to use on the switch and

whether to forward or drop filtered packets for each filter you specify.

1. Select the static filter type(s).

2. For inbound traffic matching the filter type, determine the filter action

you want for each outbound (destination) port on the switch (forward or

drop). The default action for a new filter is to forward traffic of the

specified type to all outbound ports.

3. Configure the filter.

4. Use show filter (page 11-23) to check the filter listing to verify that you

have configured correct action for the desired outbound ports.

Traffic/Security Filters and Monitors

Show Quick Links

Table of Contents