HP ProCurve 2910al Access Security Manual page 496

Configuring Port-Based and User-Based Access Control (802.1X)
Displaying 802.1X Configuration, Statistics, and Counters
ProCurve(config)# show port-access authenticator config
Port Access Authenticator Configuration
Port-access authenticator activated [No] : Yes
Allow RADIUS-assigned dynamic (GVRP) VLANs [No] : No
| Re-auth Access
Port | Period
---- + ------- -------- ----- ------- -------- ---------- -------- -----
1 | No
2 | No
...
Figure 12-11. Example of show port-access authenticator config Command
Table 12-3. Field Descriptions of show port-access authenticator config Command Output (Figure 12-11)
Field
Port-access
authenticator activated
Port
Re-auth Period
12-56
Syntax: show port-access authenticator config [port-list]
Displays 802.1X port-access authenticator configuration
settings, including:
• Whether port-access authentication is enabled
• Whether RADIUS-assigned dynamic VLANs are supported
• 802.1X configuration of ports that are enabled as 802.1X
authenticators (For a description of each setting, refer to
the syntax descriptions in "2. Reconfigure Settings for
Port-Access" on page 12-22. Use the show running
command to view the current client-limit configuration
available for switches.)
You can display 802.1X port-access authenticator
configuration for all switch ports or specified ports.
802.1X configuration information for ports that are not
enabled as 802.1X authenticators is not displayed.
Max Quiet
Control Reqs Period
Auto 2 60
Auto 2 60
Description
Whether 802.1X authentication is enabled or disabled on specified port(s).
Port number on switch.
Period of time (in seconds) after which clients connected to the port need to be re-
authenticated.
TX Supplicant Server
Timeout Timeout
30 30
30 30
Cntrl
Timeout Dir
30 both
30 in