HP ProCurve 2910al Access Security Manual page 498

Configuring Port-Based and User-Based Access Control (802.1X)
Displaying 802.1X Configuration, Statistics, and Counters
ProCurve(config)# show port-access authenticator statistics
Port Access Authenticator Statistics
Port-access authenticator activated [No] : Yes
Allow RADIUS-assigned dynamic (GVRP) VLANs [No] : No
Source
Port MAC address
---- -------------
001560-b3ea48
2
Figure 12-12. Example of show port-access authenticator statistics Command
ProCurve(config)# show port-access authenticator session-counters
Port Access Authenticator Session Counters
Port-access authenticator activated [No] : Yes
Allow RADIUS-assigned dynamic (GVRP) VLANs [No] : No
Port Frames In
---- ---------- ----------- ----------- ----------- ------ -
2 45623
Figure 12-13. Example of show port-access authenticator session-counters Command
12-58
TX TX
ReqId Req
------ ----- ------ ------- ------- ----- -------
1 0
Syntax: show port-access authenticator session-counters [port-list]
Displays information for active 802.1X authentication ses­
sions on all switch ports or specified ports that are enabled
as 802.1X authenticators, including:
• 802.1X frames received and transmitted on each port
• Duration and status of active 802.1X authentication
sessions (in-progress or terminated)
• User name of 802.1X supplicant included in 802.1X
response packets, configured with the aaa port-access
supplicant identity <username> command (see page 13-49).
802.1X configuration information for ports that are not
enabled as an 802.1X authenticators is not displayed.
Session
Frames Out Time(sec.)
45623 20
RX RX RX
Start Logoff RespId
0 0 0
Session
Status
in-progress bert
RX RX
Resp Errors
0 0
User