Kramer VS-3232DN User Manual page 43

4x4 to 32x32 modular multi-format digital matrix switcher
Hide thumbs Also See for VS-3232DN:
Table of Contents

Advertisement

3. Do one of the following:
Press BREAKAWAY to exit the Config Menu.
Wait approximately 15 seconds for the operation to time out.
Press MENU to move to the next Config Menu option.
7.2.2
Config Menu—Setting Input Port Parameters
This option sets input port-specific parameters. Ports that show an X have no
parameters available to modify. Ports that show a 0 have parameters available to
modify. The parameters that are available, such as, audio balance, depend on the
type of card installed and whether the card is an input or an output card
(see
Section 10
To set parameters for a port:
1. Press MENU twice.
The following message is displayed:
start configuration menu
MENU to view setup ENT to change them
2. Press MENU until a display is shown similar to the following:
IN:
01
SET:
X
X indicates that there are no modifiable parameters for the associated port
and 0 indicates that there are modifiable parameters for the associated port.
3. Press TAKE to enter the list of ports.
The cursor flashes on a selected port.
4. Select the required port using the left and right arrow buttons.
5. Press TAKE to enter the parameters list.
A message similar to the following is displayed with the relevant port number
in place of 06:
IN:
SET:
36
for information on the input / output cards and their parameters).
02
03
04
X
X
X
06
36.Reset SubBoard
05
06
07
0
0
X
VS-3232DN - Using the Configuration Menus
08
09
10
X
0
0
11
X

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VS-3232DN and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents