Replacing Sas Cables On A Drive Tray - Hitachi G200 Service Manual

19. Route the cables appropriately.
20. At the Replace Disk Board window, click Restore.
A progress bar shows the replacement status.
21. When the progress bar goes away and the completion message appears,
click Close.
22. Click the DKBs tab, and then check that the back end module whose
SAS cable you replaced is Normal.
23. Log out and close the Maintenance Utility window.

Replacing SAS cables on a drive tray

Replacing SAS cables for a drive tray requires you to block an ENC before
replacing the cables.
The following procedure describes how to replace SAS cables connected to a
drive tray. Wear a wrist strap connected to the storage system to prevent
part failures caused by static electricity. Do not remove the wrist strap until
you finish the procedure.
Procedure
1. Start the maintenance utility.
2. Click Hardware > Drive Box.
3. In the Drive Box window, click the ENCs tab.
4. To display the most recent status of the ENC, click Refresh.
Note: The SAS cable does not have to be routed when connecting
the DW-F800-SCQ1HA SAS adapter.
Replacing a SAS cable
Service Guide for VSP Gx00 and VSP Fx00 Models
245