4.
Push the bottom of the controller all the way into the slot. Stop pushing
when the right and left levers close completely.
5.
Tighten the blue screw to secure the controller.
6.
Confirm that the red CTL ALM LED on the new controller is off.
7.
Attach the front bezel.
Next steps
• Use the maintenance utility to restore (unblock) the controller.
Restoring a controller
Procedure
1.
At the Replace Controller Board window, click Restore. A progress bar
shows the replacement status.
Replacing a controller
Service Guide for VSP Gx00 and VSP Fx00 Models
179