Note: The SAS cable does not have to be routed when connecting
the DW-F800-SCQ1HA SAS adapter.
17.
At the Replace ENC window, click Restore.
A progress bar shows the replacement status.
18.
When the progress bar goes away and the completion message appears,
click Close.
19.
Click the ENCs tab, and then check that the ENC whose SAS cable you
replaced is Normal.
1.
Note: If the ENC status is NORMAL but the red ALARM LED does not
go out, contact the HDS Support Portal at
support.hds.com/en_us/contact-us.html.
20.
Log out and close the Maintenance Utility window.
Service Guide for VSP Gx00 and VSP Fx00 Models
Replacing a SAS cable
https://
249