Timeout
This is the value used by the printer to time out from the current port and check
the other ports for data to print. When the printer has not received data from the
host after a certain period of time, it needs to Timeout in order to service the other
ports.
v 10 Sec (the default)
v 1 Sec - 60 Sec
Report Status
When this option is enabled, faults are reported even if the fault is not on the
current active port. If the option is disabled, a fault on the printer is reported only
if it occurs on the active port.
v Disable (the default)
v Enable
Framing Errors
These are possible errors that can occur when serial interface settings of the printer
do not match those of the host computer.
v Enable (the default). If a framing error occurs, a fault message will display on
v Disable. If a framing error occurs, a fault message will not display on the
132
InfoPrint 6500-V User's Manual
the control panel.
control panel.