Table of Contents
Advertisement
Before You Begin
Read this section carefully before installing and operating the printer. The printer is
easy to install. However, for your safety and to protect valuable equipment,
perform all the procedures in this section in the order presented.
IMPORTANT: Make sure you have a way to move the printer and shipping
Power Requirements
The printer must be connected to a power outlet that supplies 88 to 135 Volts AC
or 178 to 271 Volts AC at 50 to 60 Hz. The printer automatically senses and adjusts
itself to conform to the correct voltage range.
Primary circuit protection is provided by the power switch, which is also a circuit
breaker. Consult an electrician if printer operation affects local electrical lines. See
"Electrical Characteristics" on page 257 for additional power specifications.
IMPORTANT: Printer power should be supplied from a separate AC circuit
Select a Site
Select a printer site that meets all of the following requirements:
v Cabinet models: Permits complete opening of the printer cover and both doors
v Pedestal models: Permits complete opening of the printer cover and good access
v Has a standard power outlet that supplies 88-135 Volts AC or 178-270 Volts AC
v Is relatively dust-free.
v Has a temperature range of 10 C to 40 C (50 F to 104 F) and a relative humidity
pallet. You will need a jack.
Make sure you have adequate room to maneuver the shipping
pallet and printer to the location where you plan to install the
printer.
CAUTION
<1>
Two people are required to unload the printer from the shipping pallet.
The shipping weight of the cabinet model is 129.3 kilograms (285 pounds)
or 139 kilograms (306 pounds) if the Power Paper Stacker is installed. The
shipping weight of the pedestal model printer is 72.6 kilograms (160
pounds.)
protected at 10 amperes for 100 - 120 volts or 5 amperes for 200 -
240 volts at 50 or 60 Hertz.
of the floor cabinet. Allows at least three feet of clearance behind the printer.
(This permits air to circulate freely around the printer and provides access to the
paper stacking area.)
to the paper areas at the front and rear of the printer.
power, at 47 to 63 Hz. The printer automatically senses and adjusts itself to
conform to the correct voltage range.
from 15% to 90% non-condensing.
Chapter 2. Installation, Attachment, and Configuration Overview
13
Advertisement
Table of Contents
