Table of Contents
Advertisement
SCS Buffer Control
This option is used in Coax LU1/SCS mode only.
v Don't Wait (the default). The printer does not wait for the job to be printed
before sending the print completion to the host.
v Wait Until Done. The printer waits for the job to print before sending the print
completion to the host.
This option speeds up the LU1 job printing for short jobs. If you select "Don't
Wait", there is a risk that you may not be able to recover the print job when the
printer has fault.
Cancel Buffers
CANCEL BUFFERS has the following options:
v Enable (the default). Cancels all buffers when a job is put on hold from the host
or when the CANCEL key is pressed.
v Disable. Clears the Coax internal buffer, not the print engine buffers, when a job
is put on hold from the host or when the CANCEL key is pressed.
Hex Transparent Control
You can enable additional features that are not available in standard IBM
emulations. To access these features, send lead-in character text commands in the
data stream. You can also use ASCII codes X'80' through X'9F' as control codes if
configured to do so.
Lead-In Characters
The Lead-In Character commands must have a start and end code. Set 1 is the
factory default. Three sets (each containing a start and end code) are available:
v Set 1:
v Set 2:
v Set 3:
v User Defined
User Defined Codes
v Start Code 2: X'5F'* (the default)
v Start Code 1: X'5F'
v Stop code: X'5B'
The codes can be set to X'40' - X'FF' range
start code = <%
end code = >
start code = ¬¬
end code = $
start code = _%
end code = _
Chapter 4. The Configuration Menus
71
Advertisement
Table of Contents
