Table of Contents
Advertisement
v 1 (the default)
v 2
Parity
The PARITY parameter setting can be set for the following:
v None (the default)
v Odd
v Even
v Mark
v Sense
The setting must match the corresponding parity setting in the host computer.
Data Terminal Ready
This configuration is part of hardware flow control and determines when the
DATA TERMINAL READY (DTR) signal is generated. This signal indicates
whether or not the printer is ready to receive data.
v Ready/Buffer Not Full (the default). Asserts the DTR signal when the printer is
READY and the internal serial buffer is not full.
v Not Ready/Buffer Full. Asserts the DTR signal when the printer is NOT READY
or the internal serial buffer is full.
v False. Never asserts the DTR signal.
v True. Continuously asserts the DTR signal.
Note: When the printer is attached to an System i, the DTR should be set to TRUE.
Chapter 4. The Configuration Menus
129
Advertisement
Table of Contents
