Table of Contents
Advertisement
Program Mode
The printer is in Program mode whenever the configuration menus and option
values are displayed on the operator panel message display. Program mode is
either locked or unlocked. In order to select new configuration values, you must
unlock Program mode. In order to prevent accidental changing of the configuration
settings, you may lock Program mode.
Unlocking The Program Mode
To use the operator panel to change the configuration settings, Program mode
must be unlocked. When Program mode is unlocked, pressing the Enter key selects
configuration values as the active values, that is, places them into printer DRAM.
An asterisk (*) after a displayed setting shows it is entered into memory.
Press the Return + Enter keys at the same time to unlock Program mode. The
following message will appear briefly:
EJECT key moves the paper forward to the tear–off position. In the
NOT READY state, pressing the EJECT key moves the paper
forward to the tear–off position. Pressing one of the following keys
has the function described below:
EJECT Moves the paper to its next available position. The printer
START
STOP Moves the paper to its previous position and places the
OPERATOR MENU
UNLOCKED
returns to the mode it was in before EJECT was pressed.
Moves the paper to its next available position and places
the printer in the READY state.
printer in the NOT READY state.
Chapter 3. Configuring the Printer
27
Advertisement
Table of Contents
