Table of Contents
Advertisement
Hex Transparent Control
This option allows you to enable (the default) or disable additional features that
are not available in standard IBM emulations. To access these features, send lead-in
character text commands in the data stream. You can also use ASCII codes X'80'
through X'9F' as control codes if configured to do so.
Lead-In Characters
The Lead-In Character commands must have a start and end code. Set 1 is the
factory default. Three sets (each containing a start and end code) are available:
v Set 1:
v Set 2:
v Set 3:
v User Defined
User Defined Codes
v Start Code 2: X'5F' (the default)
v Start Code 1: X'5F'
v Stop code: X'5B'
The codes can be set to X'40' - X'FF' range
Alternate Set 80 - 9F
This selection determines if ASCII codes X'80' through X'9F' will be used as control
codes or printed as standard printable characters.
v Printable (the default). Prints the alternate set as standard characters
v Control Code. Selects the alternate set to be used as printer control codes.
62
InfoPrint 6500-V User's Manual
start code = <% (default)
end code = >
start code = ¬¬
end code = $
start code = _%
end code = _
Advertisement
Table of Contents
