Table of Contents
Advertisement
Lead-In Characters
The Lead-In Character commands must have a start and end code. Set 1 is the
factory default. Three sets (each containing a start and end code) are available:
v Set 1:
v Set 2
v Set 3
v User Defined
User Defined Codes
v Start Code 2: X'5F' (the default)
v Start Code 1: X'5F' (the default)
v Stop Code: X'5B' (the default)
The codes have a range of X'40' - X'FF'.
Alternate Set 80 - 9F
This selection determines if ASCII codes X'80' through X'9F' will be used as control
codes or printed as standard printable characters.
v Printable (the default). Prints the alternate set as standard characters
v Control Code. Selects the alternate set to be used as printer control codes.
Mono/Dual Case
Specifies the font as Mono or Dual case. This option is available only in non-SCS
mode. The host will be notified of the change when the printer is placed online.
Mono Case prints the same as Dual Case if the character set is one of the following
"right to left" sets: Katak., Hebrew, Old Hebrew, and Farsi.
SCS (System Network Architecture Character String) mode is controlled by the
host computer.
v Dual Case (the default)
v Mono Case
90
InfoPrint 6500-V User's Manual
start code = <% (default)
end code = >
start code = ¬¬
end code = $
start code = _%
end code = _
Advertisement
Table of Contents
