Remedies For Misoperations - Panasonic SD-PPG100 Operating Instructions Manual

Remedies for misoperations

Pressed (Start)
before adding any
ingredients.
Pressed (Start) when
the wrong menu, raisin
and crust colour are
selected!
Install the wrong blade
and start the unit!
Pull out the power plug!
Pressed (Cancel)
erroneously during
operations!
Failed dough can be used again to make pizza and doughnuts. (P. EN44, EN46, EN66)
EN72
The ingredients other than fermented natural yeast can be added at the
following time. However, the bread making process may fail if the ingredients
are not fully mixed in the initial
Forgotten ingredients
Tips for recipe of bread with instant dry yeast
Feed into the bread pan before adding the instant dry yeast.
Pizza dough ................................................ within 1 min
Brioche, Danish bread ................................ within 5 min
Bread dough ............................................. within 10 min
Butter
Granulated sugar
Rice flour ................................................... within 35 min
Milk powder
Other menu ............................................... within 20 min
Salt
＊ Open the lid to the minimum angle to avoid spill of instant
dry yeast.
Tips for recipe of bread with natural yeast
It should be added into the bread pan within 10 minutes to
make sure that it can be mixed in the initial kneading.
Add into the yeast dispenser before the instant dry yeast is
dispensed.
Pizza dough ................................................ within 1 min
Instant dry yeast
Brioche, Danish bread ................................ within 5 min
Bread dough ............................................. within 10 min
Rice flour ................................................... within 35 min
Other menu ............................................... within 20 min
Reselect if it is just started. Hold
＊
correct, menu , raisin and crust colour and restart.
＊For rice flour bread, if you select an incorrect menu selection, you will end up with a
failure even after correcting your selection. (The initial working procedure is different.)
Press and hold (Cancel) button to stop the unit. Reinstall the correct
blade and restart the unit.
(The blade may stop rotating if it is not the correct one.)
Plug in again within 10 min after unplugging and the operation will be resumed.
＊Do not press (Start).
Press (Start) to recover within 10 min.
＊This can only be performed once. Do not press other buttons.
(kneading) procedure.
Adding time
(Cancel) to stop operation, select the