Installing An Hdd / Ssd; Figure 6: Installing An Hdd/ Ssd - Kontron KBox E-200 Series User Manual

SIM card socket is located under 2.5" HDD / SSD. To remove or install it you have first to
lift up the HDD / SSD that is screwed to a bracket.
6. For closing replace carefully the access cover to the system and screw it on with the retained screws.
7.
Tighten the retained screws when the cover is firmly in place.
When used as intended, the KBox E-200 Series is to operate only in closed condition.
Only when the access cover is properly fixed with the screws and the rear side with
WLAN antennas are properly installed and secured with the screws, it is ensured that
the user does not have access to the internal parts of the KBox E-200 Series.

5.1.1. Installing an HDD / SSD

To install an 2.5" HDD / SSD please proceed according to the steps described:
1. Open the device as described in the subsection 5.1 "Opening and Closing the KBox E-200 Series" (step 1-5).
2.
Screw the bracket to the HDD / SSD.
3. Locate the SATA socket (SATA2) (Figure 4, pos. 2) and the corresponding fixing bolts (Figure 4, pos. 10).
4. Align the notches on the HDD / SSD with the notches in the SATA socket (SATA2). Insert the HDD / SSD into the
corresponding docket (Figure 4, pos. 2) and rotate it down with the fixing hole of the bracket cover the fixing
bolts.
5. Press the HDD / SSD and its bracket down on the side with the fixing holes and secure it with the available
fastening screws (Figure 4, pos. 10).

Figure 6: Installing an HDD/ SSD

1 SATA Connector
www.kontron.com
KBox E-200 Series - User Guide, Rev. 1.0
2
1
// 28