Figure 10: Securing The Base Mounting Bracket; Figure 11: Securing The Hooked Mounting Bracket Onto The Kbox E-200 Series; Figure 12: Securing The Kbox E-200 Series Onto The Mounting Surface - Kontron KBox E-200 Series User Manual

To mount the KBox E-200 Series please proceed according to the steps described:
1. Prepare the mounting surface with sufficient screws (four screws for VESA mount) and if necessary anchors
corresponding to the mounting surface type if no VESA-compliant screw holes are available.
2. Secure the base mounting bracket to the mounting surface with screws (Figure 10). The following figures take
VESA mounting to a monitor as an example.

Figure 10: Securing the base mounting bracket

3. Secure the hooked mounting bracket onto the bottom side of the KBox E-200 (Figure 11). The front I/O panel
should be placed upward.

Figure 11: Securing the hooked mounting bracket onto the KBox E-200 Series

4. Place the KBox E-200 Series onto the mounting surface by sliding the hooked mounting bracket into the based
mounting bracket (Figure 12).
5.
Secure the hand-screw knob located on the hooked mounting bracket to fix two brackets (Figure 12).

Figure 12: Securing the KBox E-200 Series onto the mounting surface

www.kontron.com
KBox E-200 Series - User Guide, Rev. 1.0
// 34