KBox E-200 Series - User Guide, Rev. 1.0
4.2.3. Wireless LED
The Wireless LED blinks green when data is transferring.
4.2.4. Reset Button
To clear the CMOS, use the tip of a pen or straightened-out paperclip to press the button briefly (for less than three
seconds).
4.2.5. Line-Out
The stereo headphone jack is used to connect the system's audio out signal to amplified speakers or headphones.
4.2.6. Mic-In
The microphone jack is designed to connect the microphone used for video conferencing, voice narrations, or simple
audio recordings.
4.2.7. Line-In
The Line-in jack is designed to take input from a higher-powered sound source.
4.2.8. S/PFIF
The S/PDIF output connector is designed to carry digital audio signals out to external speakers or deliver compressed
AC3 signals to an external Dolby digital decoder.
4.2.9. USB 3.0
The front I/O panel of the KBox E-200 Series provides two USB 3.0 / 2.0 interface. This connector allows connection
of USB 3.0 or USB 2.0 compatible device to the system.
4.2.10. USB 2.0
The front I/O panel of the KBox E-200 Series provides two USB 2.0 / 1.1 interfaces. These connectors allow connection
of USB-compatible devices to the system.
4.2.11. eSATA
The KBox E-200 Series provides an eSATA connector on the front I/O panel. This connector allow connection of an
external SATA hard disk device to the system.
www.kontron.com
// 21