Front Fan Assembly - Lenovo 30BA User Manual

d. Insert the corresponding end of the holder into the gaps in the PCIe card latch as shown. Pivot the
holder downward to insert the part
pivot the tab on the front fan assembly to secure the holder.
Figure 130. Installing the super capacitor module
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 145.

Front fan assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
CAUTION:
Keep fingers and other parts of your body away from hazardous, moving parts. If you suffer an injury,
seek medical care immediately.
To remove or install the front fan assembly, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 63.
2. Remove the following devices if any:
• M.2 solid-state drive holder, see "M.2 solid-state drive" on page 106
• Any full-length PCIe cards, see "Full-length PCIe card" on page 124
• PCIe card retainer, see "PCIe card" on page 118
• Super capacitor module, see "Super capacitor module" on page 127
3. To remove the front fan assembly, do the following:
a
into the corresponding slot in the front fan assembly. Then,
Chapter 7
.
Hardware removal and installation
129