Lenovo 30BA User Manual page 121

4. To remove the M.2 solid-state drive holder, pull and pivot the tab on the front fan assembly as shown to
open the latch inside
Then, grasp the M.2 solid-state drive holder by its top edge and gently pull it out of the M.2 solid-state
drive slots 3 .
Figure 96. Removing the M.2 solid-state drive holder
5. To remove the M.2 solid-state drive heat sink, turn the mounting stud 90-degree counterclockwise to
release the heat sink. Then, lift the heat sink off the M.2 solid-state drive holder.
Figure 97. Removing the heat sink from the M.2 solid-state drive holder
1
. Slightly pivot the metal sheet to release the M.2 solid-state drive holder
.
Chapter 7 Hardware removal and installation
2
.
107