Lenovo 30BA User Manual page 91

4. Press both clips simultaneously toward each other and pull the conversion bracket out of the rear of the
kit.
Figure 35. Removing the conversion bracket from the kit
5. Flex both sides of the conversion bracket and then remove the 3.5-inch storage drive out of the bracket.
Do not touch the circuit board
Figure 36. Removing the 3.5-inch storage drive from the conversion bracket
6. To install a 3.5-inch storage drive, ensure that the conversion bracket is unfolded. To unfold the bracket,
do the following:
1 on the drive.
.
Chapter 7 Hardware removal and installation
77