Front Fan Assembly - Lenovo ThinkStation P920 User Manual

e. Hold the converter with the installed 2.5-inch storage drive so that the connectors face toward the
rear of the bracket and the circuit board
pins 1 on the bracket with the corresponding holes in the converter.
Note: Do not touch the circuit board
Figure 71. Installing the converter into the bracket
f. Slide the bracket together with the installed storage drive into the storage drive bay until the bracket
snaps into position.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 141.

Front fan assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
CAUTION:
Keep fingers and other parts of your body away from hazardous, moving parts. If you suffer an injury,
seek medical care immediately.
To remove or install a front fan assembly, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 61.
2. Locate the front fan assembly. See "Computer components" on page 5.
2
faces upward. Then, flex sides of the bracket and align
2 of the storage drive.
Chapter 7
.
Hardware removal and installation
95