b. Flex both sides of the bracket and align pins
new storage drive.
Note: If you are installing a 2.5-inch hard disk drive, ensure that the circuit board faces downward
and the connectors
Figure 71. Installing the storage drive into the type
5. Slide the bracket with the new storage drive into the storage drive bay.
Note: Ensure that the storage drive is on the upper side. Flip over the storage drive bracket if necessary.
Figure 72. Installing the type
6. Connect the signal cable and the power cable to the new storage drive, and then close the handles on
both sides of the bracket.
2
face toward the front of the bracket.
1
storage drive bracket
1
on the bracket with the corresponding holes in the
1
bracket
.
Chapter 7
Hardware removal and installation
95