Replacing The Front Fan Assembly - Lenovo 30A0 Hardware Maintenance Manual

8. Insert the connector and cable of the new thermal sensor into the lower hole
align the two tabs on the plastic holder holding the thermal sensor with the two holes
chassis, and push the plastic holder until it snaps into position.
Figure 52. Installing the new thermal sensor
9. Reconnect the thermal sensor cable to the system board. See "Locating parts on the system board"
on page 74.
10. Reinstall the front bezel. See "Removing and reinstalling the front bezel" on page 87.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 147.

Replacing the front fan assembly

Attention:
Do not open your computer or attempt any repair before reading and understanding "Important safety information"
on page 1.
This section provides instructions on how to replace the front fan assembly.
Note: The front fan assembly is only available in some models.
To replace the front fan assembly, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 86.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 87.
4. Disconnect the front fan assembly cable from the power fan connector on the system board. See
"Locating parts on the system board" on page 74.
.
Chapter 10 Replacing FRUs (machine types: 30A0 and 30A1)
1 in the chassis. Then
1 and 2 in the
117