Lenovo 30BA User Manual page 123

b. Align the notch 1 in the screw holder with the corresponding notch
Insert the screw holder onto the new M.2 solid-state drive as shown.
Figure 100. Inserting the screw holder onto the M.2 solid-state drive
c. Hold the new M.2 solid-state drive by its edges and ensure that the circuit board side is facing
upward. Insert the drive into the corresponding slot until it is firmly secured.
Notes:
• Pay attention to the direction of the notch
• Do not touch the circuit board of the M.2 solid-state drive.
• If only one M.2 solid-state drive is installed on the M.2 solid-state drive holder, ensure that the
drive is installed in the M.2 solid-state drive slot 1 (
7.
Figure 101. Installing the M.2 solid-state drive
2
1 in the new drive.
21 ). See "Parts on the system board" on page
.
Chapter 7 Hardware removal and installation
in the M.2 solid-state drive.
109