Task - Cisco NCS 5000 Series Manual

task

task
To add a task ID to a task group, use the task command in task group configuration mode. To remove a task
ID from a task group, use the no form of this command.
task {read| write| execute| debug} taskid-name
no task {read| write| execute| debug} taskid-name
Syntax Description
read
write
execute
debug
taskid-name
Command Default
No task IDs are assigned to a newly created task group.
Command Modes
Task group configuration
Command History
Release
Release 6.0
Usage Guidelines
Use the task command in task group configuration mode. To access task group configuration mode, use the
taskgroup command in global configuration mode.
Task ID
Task ID
aaa
Examples The following example shows how to enable execute privileges for the config-services task ID and associate
that task ID with the task group named taskgroup1:
RP/0/RP0/CPU0:router# configure
System Security Command Reference for Cisco NCS 5000 Series Routers
100
Authentication, Authorization, and Accounting Commands
Enables read-only privileges for the named task ID.
Enables write privileges for the named task ID. The term "write" implies
read also.
Enables execute privileges for the named task ID.
Enables debug privileges for the named task ID.
Name of the task ID.
Operations
read, write
Modification
This command was introduced.