Show Radius Dead-Criteria - Cisco NCS 5000 Series Manual

Authentication, Authorization, and Accounting Commands

show radius dead-criteria

To obtain information about the dead server detection criteria, use the show radius dead-criteria command
in the XR EXEC mode.
show radius dead-criteria host ip-addr [auth-port auth-port] [acct-port acct-port]
Syntax Description
host ip-addr
auth-port auth-port
acct-port acct-port
Command Default
The default values for time and tries are not fixed to a single value; therefore, they are calculated and fall
within a range of 10 to 60 seconds for time and 10 to 100 for tries.
Command Modes
XR EXEC mode
Command History
Release
Release 6.0
Usage Guidelines
No specific guidelines impact the use of this command.
Task ID
Task ID
aaa
Examples
The following sample output is for the show radius dead-criteria command:
RP/0/RP0/CPU0:router# show radius dead-criteria host 12.26.49.12 auth-port 11000 acct-port
11001
Server: 12.26.49.12/11000/11001
Dead criteria time: 10 sec (computed) tries: 10 (computed)
This table describes the significant fields shown in the display.
Specifies the name or IP address of the configured RADIUS server.
(Optional) Specifies the authentication port for the RADIUS server. The
default value is 1645.
(Optional) Specifies the accounting port for the RADIUS server. The
default value is 1646.
Operations
read
System Security Command Reference for Cisco NCS 5000 Series Routers
show radius dead-criteria
Modification
This command was introduced.
75