Ieee 802.1Q Encapsulation Configuration Task List - Cisco 1710 Software Configuration Manual

Configuring Routing Between VLANs
with IEEE 802.1Q Encapsulation
This chapter describes the required and optional tasks for configuring routing
between VLANs with IEEE 802.1Q encapsulation. For complete descriptions of
the VLAN commands used in this chapter, refer to the "Cisco IOS Switching
Commands" chapter in the Cisco IOS Switching Services Command Reference.
For documentation of other commands that appear in this chapter, you can either
use the command reference master index or search online.
The IEEE 802.1Q protocol is used to interconnect multiple switches and routers
and for defining VLAN topologies. IEEE 802.1Q support is currently available
for Fast Ethernet interfaces.
The Cisco 1710 Security router supports IEEE 802.1Q only on the Fast
Note
Ethernet interface.

IEEE 802.1Q Encapsulation Configuration Task List

You can configure routing between any number of VLANs in your network. This
section documents the configuration tasks for each protocol supported with
IEEE 802.1Q encapsulation. The basic process is the same, regardless of the
protocol being routed. It involves:
78-12696-01
Enabling the protocol on the router
•
• Enabling the protocol on the interface
Cisco 1710 Security Router Software Configuration Guide
C H A P T E R
4
4-1