Management Plane Protection Commands; Chapter - Cisco NCS 5000 Series Manual
System security command reference for cisco ncs 5000 series
routers
Hide thumbs
Also See for Cisco NCS 5000 Series:
- Hardware installation manual (72 pages) ,
- Manual (188 pages)
Table of Contents
Advertisement
Management Plane Protection Commands
This module describes the commands used to configure management plane protection (MPP).
For detailed information about keychain management concepts, configuration tasks, and examples, see the
Implementing Management Plane Protection chapter in the System Security Configuration Guide for Cisco
NCS 5000 Series Routers.
Note
Currently, only default VRF is supported. VPNv4, VPNv6 and VPN routing and forwarding (VRF) address
families will be supported in a future release.
•
address ipv4 (MPP), page 130
•
address ipv6 (MPP), page 132
•
allow, page 133
•
control-plane, page 135
•
inband, page 136
•
interface (MPP), page 137
•
management-plane, page 139
•
show mgmt-plane, page 140
System Security Command Reference for Cisco NCS 5000 Series Routers
129
- Quick Links:
- Aaa Accounting
- Secure Shell Commands
- Sftp
Hide quick links:
Advertisement
Table of Contents
